6C13G11 3-14123456789Checking the power trim and tilt fluidlevel1. Fully tilt the outboard motor up, and thensupport it with the tilt stop lever 1.WARNINGAfter tilting up the outboard motor, besure to support it with the tilt stop lever.Otherwise, the outboard motor could sud-denly lower if the power trim and tilt unitshould lose fluid pressure.2. Remove the reservoir cap 2, and thencheck the fluid level in the reservoir.NOTE:If the fluid is at the correct level, the fluidshould overflow out of the filler hole when thereservoir cap is removed.3. If necessary, add sufficient fluid of therecommended type until it overflows outof the filler hole.4. Install the reservoir cap, and then tightenit to the specified torque.Lower unit 3Checking the gear oil level1. Fully tilt the outboard motor down.2. Remove the check screw 1, and thencheck the gear oil level in the lower case.NOTE:If the oil is at the correct level, the oil shouldoverflow out of the check hole when thecheck screw is removed.S6C13360121S6C13300Recommended power trim and tiltfluid:ATF Dexron IIT R..Reservoir cap:7 N·m (0.7 kgf·m, 5.2 ft·lb)S60V33201Control system / Bracket unit / Lower unit
