Yamaha F75D Ower's Manual

Contents

Operation29EMU27784Reverse (automatic reverse lock andpower trim and tilt models)WARNINGEWM00190When operating in reverse, go slowly. Donot open the throttle more than half. Other-wise the boat could become unstable,which could result in loss of control andan accident.Tiller control models1. Place the throttle grip in the fully closedposition.2. Move the gear shift lever quickly and firm-ly from neutral to reverse.Remote control modelsPull up the neutral interlock trigger (ifequipped) and move the remote control leverquickly and firmly from neutral to reverse.EMU27820Stopping engineBefore stopping the engine, first let it cool offfor a few minutes at idle or low speed. Stop-ping the engine immediately after operating athigh speed is not recommended.EMU27851Procedure1. Turn the main switch to “ ” (off).2. After stopping the engine, disconnect thefuel line or close the fuel cock if there is afuel joint or a fuel cock on the boat.3. Tighten the air vent screw on the fuel tankcap (if equipped).4. Remove the key if the boat will be left un-attended.NOTE:The engine can also be stopped by pulling thelanyard and removing the clip from the enginestop switch, then turning the main switch to“ ” (off).EMU27861Trimming outboard motorThe trim angle of the outboard motor helpsdetermine the position of the bow of the boatin the water. Correct trim angle will help im-prove performance and fuel economy whilereducing strain on the engine. Correct trim an-gle depends upon the combination of boat,