Configuring the Handset123Parameters PermittedValues DefaultNote: It will take effect on all handsets that are registered on the same base station. Itworks only if the value of the parameter “auto_provision.handset_configured.enable” is setto 1 (Enabled).Note: It is not applicable to W56H handset.Web User Interface:Nonehandset User Interface:OK->Settings->Display->Notification LED->Voice Mailcustom.handset.missed_call_notify_light.enable 0 or 1 1Description:Enables or disables the message key LED to flash red when the handset misses a call.0-Disabled1-EnabledNote: It will take effect on all handsets that are registered on the same base station. Itworks only if the value of the parameter “auto_provision.handset_configured.enable” is setto 1 (Enabled).Note: It is not applicable to W56H handset.Web User Interface:Nonehandset User Interface:OK->Settings->Display->Notification LED->Missed CallTo configure notification light via handset user interface:1. Press OK to enter the main menu.2. Select Settings->Display->Notification LED.3. Press or to select the desired value from the Voice Mail field.4. Press or to select the desired value from the Missed Call field.5. Press the Save soft key to accept the change or the Back soft key to cancel.Advisory ToneAdvisory tones are acoustic signals of your handset, which inform you of different actions andstates. The following advisory tones can be configured independently of each other: Keypad Tone: plays when a user presses any key of the keypad.
