Zanussi ZCM 610 X Instruction Booklet

Zanussi ZCM 610 X Instruction Booklet Manual pdf 24 page image

24115780420ABCDEInstallationFig. 1Positioning the Appliance (Fig. 1)Note A:The appliance is designed to be flush fitted with2mm clearance at each side to allow for it to bepulled forward for cleaning etc.Note B:The hotplate side trims should be flush with thecabinets and must not be below. Adjustable levellingfeet at the front and rear are provided on the base ofthe appliance. Adjustment is obtained by rotating inor out, the feet at the front or rear of the appliancefrom the underside of the appliance.A spirit level should be placed on a cake tray on oneof the shelves to confirm that the appliance iscorrectly levelled.The levelling feet fitted to the appliance will achievea height to hotplate trims of 900mm-0 + 10.Note C:If the appliance is fitted next to a side wall orcabinets above height of the hotplate trims, then agap of 115 mm is required.Curtains must not be fitted immediately behind thecooker or within 115 mm of the sides of the cooker.Note D:Any wall cabinet or extractor must not be lower than780mm above hotplate level.Note E:Wall cabinets may be fitted in line with the sides ofthe base units, providing that the lower edge of thewall cabinet is a minimum of 420mm above theworktop.The appliance must be installed in accordance to thetype X (standard EN 60335-2-6).Therefore the appliance can not be installed besidefurniture higher than the cooker worktop.FO 1141