Zanussi ZCM 610 X Instruction Booklet

Zanussi ZCM 610 X Instruction Booklet Manual pdf 25 page image

25LEVELLING FEETPENCIL LINE ON THE FLOORPLAN VIEW OF THE COOKER480 mm.100 mm.300 mm.295 mm.WALL FACEABACK OF COOKERSIDE VIEWOF THE COOKERBASE OF COOKERENGAGEMENT EDGE FORSTABILITY BRACKETFig. 3Fitting the Stability Bracket(Not supplied)If the cooker has to be installed with a flexiblesupply pipe, it is necessary that a stability device isfitted.(See safety Requirements: Page 23).If a stability bracket should be fitted by the installer,these instructions should be read in conjunction withthe leaflet packed with the stability bracket.Place cooker in its intended position and levelcooker.Mark off 295mm (11 1 / 2") from the right hand side ofthe cooker as shown, this is the centre line of thebracket fixing.Draw a line 100mm (4") from the front edge of thelevelling feet (see Fig. 17) and remove cooker fromits position. Mark off 480mm (19") back from thisline on the centre line of the bracket to locate thefront edge of the lower bracket.Fix lower bracket (with two fixing holes) to the floor,then measure height from floor level to engagementedge on back of cooker, dimension 'A' of Fig. 2.Assemble upper bracket to lower bracket so thatunderside of bracket is dimension 'A' +3mm (1/8")above floor level. Re-position cooker and check thattop bracket engages into cooker back to a depth of75mm (3"), as shown in Fig. 2.Should the stability bracket currently installed notallow the cooker to stand correctly, ask the installerto replace it with the correct type.Fig. 2Connecting to GasThis cooker is designed to be installed with anappliance flexible connection. Connection is made tothe RC 1/2 (1/2" B.S.P.) threaded entry pipe locatedjust below the hotplate level on the rear right-handside of the cooker. Check for gas soundness afterconnecting the gas supply.The gas bayonet connector must be fitted in theshaded area indicated in Fig. 3. Take into accountthat it must be possible to pull the cooker forwardsufficiently. The hose must not get caught on thestability bracket.Note:If using different types of gas bayonet connection, itmay not be possible for the appliance to be pushedfully back to the wall stops.Important:Flexible tubing MUST comply with BS.669 CurrentEdition.FO 0179FO 0180600450130

/ 28

Related manuals for Zanussi ZCM 600 W