Warning! Deactivate the appliance beforeyou do the checks. Turn the programmeknob until the programme marker is aligned withthe on/off indicator.Problem Possible solutionYou cannot activate the appliance. Make sure that the mains plug is connected to the mainssocket.Make sure that there is not a damaged fuse in the fuse box.The programme does not start. Make sure that the appliance door is closed.Press the start button.If the delay start is set, cancel the setting or wait for the endof the countdown.The appliance does not fill with water. Make sure that the water tap is open.Make sure that the pressure of the water supply is not toolow. For this information, contact your local water authority.Make sure that the water tap is not clogged.Make sure that the filter in the inlet hose is not clogged.Make sure that the inlet hose has no kinks or bends.The appliance does not drain the water. Make sure that the sink spigot is not clogged.Make sure that the drain hose has no kinks or bends.The anti-flood device is on. Close the water tap and contact the Service.After the checks are completed, turn the pro-gramme knob until the programme marker isaligned with programme that was in operationwhen the problem occurred. The programmecontinues from the point of interruption.If the problem occurs again, contact the Serv-ice.If other alarm codes show, contact the Service.If the washing and drying results are notsatisfactoryWhitish streaks or bluish layers onglasses and dishes• The released quantity of rinse aid is toomuch. Adjust the rinse aid selector to a lowerposition.• The quantity of detergent is too much.Stains and dry water drops on glasses anddishes• The released quantity of rinse aid is not suffi-cient. Adjust the rinse aid selector to a higherposition.• The quality of the detergent can be thecause.Dishes are wet• The programme is without a drying phase orwith a low temperature drying phase.• The rinse aid dispenser is empty.• The quality of the rinse aid can be the cause.Refer to ‘HINTS AND TIPS’ for other pos-sible causes.Technical informationDimensions Width / Height / Depth (mm) 446 / 850 / 605Electrical connection Refer to the rating plate.Voltage 220-240 V12 www.zanussi.com