Using the detergentCaution! Use only detergents fordishwashers.Do not use more than the correct quantityof detergent. Refer to the instructions onthe detergent packaging.1 234 5If the programme hasa prewash phase, puta small quantity of de-tergent on the innerpart of the appliancedoor.Detergent tablets do not fully dissolve withshort programmes and detergent residuescan stay on the dishes.We recommend that you use detergent tabletswith long programmes.Combi detergent tabletsThese tablets contain detergent, rinse aid andother added agents. Be sure that these tabletsare applicable to the water hardness in yourarea. Refer to the instructions on the packagingof the products.When you use tablets, that contain salt andrinse aid, do not fill the salt container and therinse aid dispenser. The rinse aid indicator al-ways comes on if the rinse aid dispenser isempty.1. Adjust the water softener to the lowest level.2. Set the rinse aid dispenser to the lowest po-sition.If you stop to use the combi detergenttablets, before you start to use separatelydetergent, rinse aid and dishwasher salt,do these steps:1. Press the on/off button to activate the appli-ance.2. Set the water softener to the highest level.3. Make sure that the salt container and therinse aid dispenser are full.4. Start the shortest programme with a rinsingphase, without detergent and withoutdishes.5. Adjust the water softener to the water hard-ness in your area.6. Adjust the released quantity of rinse aid.Setting and starting a programmeSetting modeThe appliance must be in setting mode tostart a programme.• Turn the programme knob until the pro-gramme marker is aligned with a programmeon the control panel. If the on/off indicatorcomes on, the appliance is in setting mode.• Turn the programme knob until the pro-gramme marker is aligned with a programmeon the control panel. If the on/off indicatorand the start indicator come on, the applianceis not in setting mode.8 www.zanussi.com