Zanussi ZOP37982XC User Manual

Also see for ZOP37982XC: User manual

Contents

4. Put the door on a soft cloth on a stable surface.5. Hold the door trim (B) on the top edge of thedoor at the two sides and push inwards torelease the clip seal.12B6. Pull the door trim to the front to remove it.7. Hold the door glass panels by their top edgeand carefully pull them out one by one. Startfrom the top panel. Make sure the glass slidesout of the supports completely.8. Clean the glass panels with water and soap.Dry the glass panels carefully.When the cleaning is completed, install the glasspanels and the oven door. Do the above steps inthe opposite sequence.Make sure that you put the glass panels (A, B andC) back in the correct sequence. The middle panel(B) has a decorative frame. The screen-printingzone must face the inner side of the door. Makesure that after the installation the surface of theglass panel frame (B) on the screen-printing zonesis not rough when you touch it.A B CMake sure that you install the middle panel of glassin the seats correctly.ABCREPLACING THE LAMPPut a cloth on the bottom of the interior of theappliance. It prevents damage to the lamp glasscover and the cavity.WARNING! Danger of electrocution!Disconnect the fuse before youreplace the lamp.The lamp and the lamp glass covercan be hot.CAUTION! Always hold the halogenlamp with a cloth to prevent greaseresidue from burning on the lamp.1. Deactivate the appliance.2. Remove the fuses from the fuse box ordeactivate the circuit breaker.The back lamp1. Turn the lamp glass cover counterclockwise toremove it.2. Clean the glass cover.3. Replace the lamp with a suitable 300 °C heat-resistant lamp.4. Install the glass cover.22