Configure Using AutoNet Method Revised 2017-08-31Accessing the Web User Interface Drawing No. LP0997-C- 2 - Sixnet ® Series SN/RAM ® 6000 & RAM 9000 Software Manual1.1 Configure Using AutoNet MethodWhen using AutoNet, connect the eth0 port to any Ethernet network or directly to a PC. It will discover otherDHCP networks and will either join automatically or provide a DHCP address to the connected PC.Inspect the product label on your unit to find the field “Eth0 MAC” and notice the last 6 digits or letters.If your MAC address was 02‐FF‐EE‐1A‐34‐5B, then the unit can be accessed by entering http://RAM-1A345B.localin your browser.Once you configure your Ethernet port for use in production, AutoNet will be automatically disabled. If AutoNetdoes not seem to be working in your environment, you can always fall back to the previously supported methodsof access 1.2 and 1.3.1.2 Setup PC IP Address1.2.1 Open the Control PanelClick on Start and browse the “Control Panel” menu item. The Control Panel should look similar to the following:1.2.2 Access Network and SettingsClick on the link to access network and Internet settings• XP - “Network and Internet Connections”• Vista/Windows 7 “Network and Internet”
