DaVinci Category 2 manuals
Category 2
Table of contents
- listing details
- Table Of Contents
- safety warnings
- installation options
- Category 2 Dimensions – Single Sided or See Through Configurations
- Category 2 Dimensions – Pier Configuration
- Category 2 Dimensions – Island Configuration
- Category 2 Dimensions – Full Bay Configuration
- Category 2 Dimensions – Right Side Corner Configuration
- Category 3 Dimensions – Single Sided or See Through Configurations
- Category 3 Dimensions – Pier Configuration
- Category 3 Dimensions – Island Configuration
- Category 3 Dimensions – Full Bay Configuration
- Category 3 Dimensions – Right Side Corner Configuration
- packing list for fireplace modules
- Joining Components
- recommended installation procedure
- massachusetts requirements
- alignment track installation
- remove the shipping end caps from fireplace modules
- remove components to allow for fireplace joining
- slide the fireplace modules together
- Install Upper Titan Lock Braces (do not fully tighten)
- Install Lower Titan Lock Braces (do not fully tighten)
- place installation alignment tool in center of glass opening and adjust
- attach tension rods
- tightening the titan lock connectors
- secure the fireplace to the alignment track
- Overhead Light Connection – Category 2+ Units
- attach the gas and electrical lines between the fireplace modules
- Pressure Switch Tube Installation (Category 3 Only)
- fireplace placement requirements
- Typical Framing Dims. – One Sided Configuration
- Typical Framing Dims. – See Through Configuration
- Typical Framing Dims. – Pier Configuration
- Typical Framing Dims. – Island Configuration
- Typical Framing Dims. – Full Bay Configuration
- Typical Framing Dims – Right-Sided Corner
- Typical Framing Dims – Left-Sided Corner
- nailing brackets
- accessing internal components
- gas line requirements
- gas inlet location
- electrical junction box
- electrical input connection
- Connecting the Power Vent Lead to the Fireplace
- Connecting the Exhaust Damper Harness to the Fireplace
- Wiring the Power Vent
- Wiring the Power Vent (continued)
- Connecting the Intake Damper Harness to the Fireplace
- Wiring the Intake Damper
- Connecting the CAT5 Harness to the Fireplace
- Installing the TouchSmart Controller
- TouchSmart Mounting Box
- air intake requirements
- intake dampers
- Air Intake Duct Quantity and Location – Category 2
- Air Intake Duct Quantity and Location – Category 3
- Air intake Installation – Hood Versions (includes external dampers)
- Internal Dampers (for Hori. or Vert. Termination)
- installation considerations
- vent requirements
- approved vent configurations
- rheostat adjustment
- termination requirements
- Interior Power Vent – Dimensions and Mounting
- hearth requirements
- mantel requirements
- fireback installation
- glass pane installation and removal
- steps for finalizing the installation
- crushed glass installation
- wiring diagram
- before you begin
- Location of Controls
- yearly service procedure
- bulb replacement
- gas control assembly
manualsdatabase
Your AI-powered manual search engine