Yamaha FT60D manuals
FT60D
Table of contents
- important manual information
- Table Of Contents
- Table Of Contents
- General information
- Safety information
- Important labels
- Fueling instructions
- Battery requirement
- Start-in-gear protection
- Basic components
- Fuel tank
- Air vent screw
- Neutral interlock trigger
- Tiller handle
- Engine stop lanyard switch
- Engine stop button
- Steering friction adjuster
- Variable trolling RPM switches
- Trim tab with anode
- Tilt support lever for power trim and tilt or hydro tilt model
- Warning indicator
- Low oil pressure warning indicator
- Overheat warning indicator (digital type)
- Trim meter
- Trip meter
- Fuel gauge
- Y8 Multifunction meters
- Speedometer unit
- Fuel management meter
- Low oil pressure warning
- Operation
- Breaking in engine
- Controls
- Operating engine
- Starting engine
- Warming up engine
- Reverse (automatic reverse lock and power trim and tilt models)
- Trolling
- Trimming outboard motor
- Adjusting trim angle
- Adjusting boat trim
- Cruising in shallow water
- Cruising in other conditions
- Maintenance
- Transporting and storing outboard motor
- Procedure
- Lubrication
- Flushing power unit
- Cleaning the outboard motor
- Maintenance chart
- Maintenance chart (additional)
- Greasing
- Cleaning and adjusting spark plug
- Checking fuel system
- Inspecting idling speed
- Checking wiring and connectors
- Checking propeller
- Removing the propeller
- Changing gear oil
- Cleaning fuel tank
- Inspecting and replacing anode(s)
- Connecting the battery
- Disconnecting the battery
- Trouble Recovery
- Temporary action in emergency
- Power trim and tilt / power tilt will not operate
- Starter will not operate
- Emergency starting engine
- Treatment of submerged motor
FT60D
Table of contents
- important information
- General information
- General information
- Specifications
- safety while working
- good working practices
- serial number
- outline of features
- features and benefits
- solenoid valve
- electronic control system
- ecm (electric control module)
- variable trolling rpm switch (optional)
- propeller selection
- predelivery checks
- checking the power trim and tilt system
- test run
- general specifications
- maintenance specification
- tightening torques
- Periodic checks and adjustments
- Periodic checks and adjustments
- special service tools
- maintenance interval chart
- fuel system
- changing the engine oil by draining it
- replacing the oil filter
- replacing the timing belt
- checking the spark plugs
- checking the thermostat
- checking the gear shift operation
- bracket unit
- lower unit
- changing the gear oil
- checking the anodes
- Fuel system
- Table Of Contents
- hose routing
- cooling water pilot hoses
- fuel filter and fuel pump
- checking the fuel pump
- checking the diaphragm and valves
- intake manifold
- checking the idle speed control
- vapor separator
- disconnecting the quick connector
- checking the pressure regulator
- disassembling the vapor separator
- checking the vapor separator
- Power unit
- Table Of Contents
- Table Of Contents
- checking the compression pressure
- removing the timing belt and sprockets
- cylinder head
- checking the valve guides
- refacing the valve seat
- checking the camshaft
- checking the oil pump
- installing the oil pump
- installing the cylinder head
- exhaust cover
- cylinder block
- checking the piston diameter
- checking the piston ring side clearance
- selecting the connecting rod bearing
- installing the power unit
- Lower unit
- Table Of Contents
- propeller shaft housing (f50, f)
- drive shaft and lower case (f50, f)
- disassembling the lower case
- installing the water pump
- selecting the reverse gear shims
- checking the propeller shaft
- assembling the lower case
- installing the water pump and shift rod
- Bracket unit
- Table Of Contents
- Table Of Contents
- bottom cowling
- assembling the oil pan
- assembling the upper case
- installing the upper case
- steering arm
- clamp brackets and swivel bracket
- removing the clamp brackets
- power trim and tilt motor
- disassembling the power trim and tilt motor
- assembling the power trim and tilt motor
- gear pump
- tilt cylinder and trim cylinder
- assembling the tilt cylinder
- assembling the power trim and tilt unit
- installing the power trim and tilt unit/hydro unit
- power trim and tilt electrical system
- checking the trim sensor
- Electrical systems
- Table Of Contents
- Table Of Contents
- Troubleshooting
- electrical components
- bow view
- starboard view
- top view
- tiller handle model
- ignition and ignition control system
- checking the pulser coil
- checking the sensor assembly
- checking the cooling water temperature sensor
- fuel control system
- checking the solenoid valve
- starting system
- starter motor
- electrical systems
- checking the magnet switch
- charging system
- power unit
- Table Of Contents
- Symbols
FT60D
Table of contents
- important manual information
- Table Of Contents
- Table Of Contents
- Table Of Contents
- safety information
- carbon monoxide
- passenger training
- general information
- C-Tick label
- read manuals and labels
- specifications and requirements
- installation requirements
- multiple batteries
- engine oil requirements
- fuel requirements
- components diagram
- Fuel tank
- Fuel joint
- Neutral interlock trigger
- gear shift lever
- throttle indicator
- engine stop button
- main switch
- power trim and tilt switch on remote control or tiller handle
- trim tab with anode
- Tilt support lever for power trim and tilt model
- Flushing device
- instruments and indicators
- Tachometer
- digital speedometer
- Trip meter / Clock / Voltmeter
- analog tachometer
- y8 multifunction meters
- Start-up checks
- Low oil pressure-alert
- engine trouble alert
- Y8 Multifunction speedometers
- y8 multifunction fuel management meters
- engine control system
- low oil pressure alert
- mounting the outboard motor
- fill engine oil
- remove the top cowling
- Engine shut-off cord (lanyard)
- engine oil
- install top cowling
- filling fuel
- operating engine
- starting engine
- warming up engine
- checks after engine warm up
- stopping boat
- trimming outboard motor
- adjusting boat trim
- tilting up and down
- shallow water
- cruising in other conditions
- transporting and storing outboard motor
- Procedure
- Lubrication
- flushing power unit
- outboard motor
- severe operating conditions
- maintenance chart 1
- maintenance chart 2
- Greasing
- Cleaning and adjusting spark plug
- inspecting idle speed
- inspecting wiring and connectors
- installing propeller
- Changing gear oil
- Cleaning fuel tank
- Inspecting and replacing anode(s)
- connecting the battery
- disconnecting the battery
- trouble recovery
- replacing fuse
- power trim and tilt will not operate
- Water separator-alert indicator blinks while cruising
- Starter will not operate
- treatment of submerged motor
FT60D
Table of contents
- important manual information
- Table Of Contents
- Table Of Contents
- Table Of Contents
- safety information
- boating safety
- Avoid collisions
- general information
- read manuals and labels
- specifications and requirements
- installation requirements
- Start-in-gear protection
- engine oil requirements
- motor disposal requirements
- components diagram
- Fuel tank
- Fuel gauge
- Neutral interlock trigger
- Tiller handle
- Throttle friction adjuster
- Engine stop button
- Steering friction adjuster
- Power trim and tilt switch on remote control or tiller handle
- Variable trolling RPM switches
- Tilt support lever for power trim and tilt model
- Fuel filter/Water separator
- instruments and indicators
- Tachometer
- digital speedometer
- Trip meter / Clock / Voltmeter
- analog tachometer
- y8 multifunction meters
- Start-up checks
- Water separator alert
- y8 multifunction speedometers
- engine control system
- Low oil pressure alert
- Installation
- checks before starting engine
- Fuel level
- Engine shut-off cord (lanyard)
- Engine
- filling fuel
- operating engine
- Starting engine
- warming up engine
- Checks after engine warm-up
- stopping boat
- trimming outboard motor
- Adjusting trim angle (Power trim and tilt)
- Adjusting boat trim
- tilting up and down
- Procedure for tilting down (power trim and tilt models)
- shallow water
- cruising in other conditions
- transporting and storing
- Procedure
- Lubrication
- Cleaning the outboard motor
- periodic maintenance
- Maintenance chart 1
- maintenance chart 2
- Greasing
- Cleaning and adjusting spark plug
- Inspecting idling speed
- Changing engine oil
- Checking wiring and connectors
- Removing propeller
- Changing gear oil
- Cleaning fuel tank
- Inspecting and replacing anode(s)
- Checking battery (for electric start models)
- Disconnecting the battery
- trouble recovery
- temporary action in emergency
- Power trim and tilt will not operate
- Starter will not operate
- Emergency starting engine
- treatment of submerged motor
FT60D
Table of contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Safety information
- Gasoline exposure and spills
- Avoid collisions
- General information
- Read manuals and labels
- Specifications and requirements
- Installation requirements
- Mounting motor
- Start-in-gear protection
- Fuel requirements
- Emergency equipment
- Components
- Fuel tank
- Fuel gauge
- Neutral interlock trigger
- Tiller handle
- Throttle friction adjuster
- Engine stop button
- Steering friction adjuster
- Power trim and tilt switch on remote control or tiller handle
- Variable trolling RPM switches
- Tilt support lever for power trim and tilt model
- Fuel filter/Water separator
- Instruments and indicators
- Tachometer
- Overheat-alert indicator
- Trip meter / Clock / Voltmeter
- Fuel level-alert indicator
- Start-up checks
- Water separator alert
- Y8 Multifunction speedometers
- Engine control system
- Low oil pressure alert
- Installation
- Operation
- Remove cowling
- Engine shut-off cord (lanyard)
- Engine
- Power trim and tilt system
- Operating engine
- Starting engine
- Checks after starting engine
- Warming up engine
- Stopping boat
- Stopping engine
- Trimming outboard motor
- Adjusting boat trim
- Tilting up and down
- Shallow water
- Cruising in other conditions
- Maintenance
- Procedure
- Lubrication
- Cleaning the outboard motor
- Replacement parts
- Maintenance chart 1
- Maintenance chart 2
- Greasing
- Cleaning and adjusting spark plug
- Inspecting idling speed
- Checking wiring and connectors
- Removing propeller
- Changing gear oil
- Cleaning fuel tank
- Inspecting and replacing anode(s)
- Connecting the battery
- Trouble Recovery
- Temporary action in emergency
- Power trim and tilt will not operate
- Starter will not operate
- Emergency starting engine
- Treatment of submerged motor
FT60D
Table of contents
manualsdatabase
Your AI-powered manual search engine