Raymarine SmartPilot ST7002 manuals
SmartPilot ST7002
Table of contents
- important information
- safety notices
- connections to other equipment
- Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Chapter 1: System Connections
- The SmartPilot computer
- Removing and replacing the connector cover
- Computer inputs, outputs and fuses
- Connecting the Power and the Drive unit
- Grounding the SmartPilot
- Fuse Protection
- Securing the Cables
- Isolated control unit, single power supply (S2 and S3 computers only)
- Connecting SeaTalk or NMEA compasses
- How to connect NMEA equipment
- SmartPilot computer NMEA inputs/outputs
- How to connect optional components
- External alarm
- Selecting clutch voltage (S3 & S3G only)
- Secure the cables
- WARNING: Calibration requirement
- Step 1 - Switch on
- NMEA navigator connections
- Check the autopilot steering sense
- Enter Dealer Calibration mode
- Set the drive type
- Align the rudder position sensor
- Seatrial Calibration
- Calibrating the compass
- Adjusting the heading alignment
- Manual set-up: Non-G Systems
- Adjusting the rudder gain
- Adjusting the counter rudder
- Further adjustments (Non-G)
- Calibration basics
- Accessing the Calibration modes
- Display Calibration
- Display Calibration screens
- Data
- User Calibration
- Dealer Calibration
- Dealer Calibration screens and settings
- Drive type
- Rudder limit
- Rudder damping
- Response level
- Off course warning angle
- AutoRelease (I/O drives only)
- Wind selection
- AutoAdapt
- System reset
- Dealer Calibration defaults
- Dealer Calibration defaults
- Dealer Calibration options
- Chapter 4: Fault Finding & Maintenance
- SmartPilot alarm messages
- Maintenance
- Product support
- SmartPilot Specifications
- WARNING: Potential ignition source
- Glossary
- Index
- Table Of Contents
- raymarine world wide warranty
- product warranty
- warranty limitations
SmartPilot ST7002
Table of contents
- important information
- product disposal
- handbook information
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Introduction
- Extended systems
- Start-up mode
- What does the display tell me
- Using the SmartPilot to steer your boat
- Can I dodge an obstacle and then resume course
- Off Course warning
- How do I prevent accidental gybes
- Can I adjust the display lighting & contrast
- How do I adjust the contrast
- How do I follow a route set on a Chartplotter
- How do I leave Track mode
- Tidal stream compensation
- What happens when I arrive at a waypoint
- What is the Waypoint Advance warning
- Using Wind Vane mode – sail boats
- How do I leave Wind Vane mode
- What is a Wind Shift warning
- Operating hints for Wind Vane mode
- Can I display Waypoint names
- User Calibration Options
- Gybe inhibit (SAILBOAT only)
- Chapter 3: Fault Finding & Maintenance
- SmartPilot alarm messages
- General maintenance
- EMC advice
- software information
- Product details table
- Specifications
- Glossary
- Index
SmartPilot ST7002
Table of contents
Related products
SmartPilot ST7001SmartPilot ST6002SmartPilot ST8002SmartPilot X5SmartPilot ST8001SmartPilot ST6001SmartPilot X-5RSmartPilot SPX-SOLSmartPilot SPX-SALSmartPilot SeriesRaymarine categories
Marine Equipment
Monitor
GPS
Marine GPS System
Autopilot System
Fish Finder
Transducer
Radio
Thermal cameras
Marine Radar
manualsdatabase
Your AI-powered manual search engine