3Com OfficeConnect 3CR414492 Getting Started Manual

Contents

3Com OfficeConnect 3CR414492 Getting Started Manual Manual pdf 22 page image

2-4 C HAPTER 2: INSTALLING THE O FFICE C ONNECT R EMOTE 812 ADSL R OUTER Use Port 1 to connect to another hub with the MDI/Xbutton pressed in. You can then connect the otherworkstations to the other hub. Connect to an Ethernet Hub — Press the MDI/Xbutton in on the back panel and plug the 10Base-Tcable into the right-hand LAN port (Port 1).5 Connect the Console Cable (optional). If Windows is youroperating system, you do not need to connect the consolecable because you use the Remote 812 Manager toconfigure your unit. The Remote 812 Manager uses a webbrowser instead of a Command Line Interface (CLI). If youroperating system is Macintosh or Unix, use the CLI.6 Locate the serial cable included in your package. Connectone end of the cable to the DB-9 console port on the OCR812 and plug the other end into a serial port on yourworkstation.The OCR 812 Hardware Installation is now complete.Continue with the next section to verify that your OCR 812is operating correctly.LED Light OperationAfter you boot up, the LEDs indicate if the OCR 812 isworking properly and when certain features are in use.There are four sets of LEDs on the OCR 812. They operateas shown in the following table:Table 2-1 LED OperationLED Group LED Indicator Status OperationAlert Flashing Software is initializing.Power Power ON Power is on.ADSL LinkStatusADSLconnectionOFFGreenBlinkingGreenOrangeNo signal has been detected.Link is up.Link is up, data transfer is occurring.The unit is attempting to achievesynchronization with the central office(CO) equipment.LAN Status(Ports 1-4)ClientConnectionON A client is connected to thecorresponding port on the hub.