3Com OfficeConnect 3CR414492 Getting Started Manual

Contents

3Com OfficeConnect 3CR414492 Getting Started Manual Manual pdf 36 page image

3-2 C HAPTER 3: TESTING THE C ONFIGURATIONStep 2: Check Network Status1 Check that all LAN and WAN networks are up. From theOfficeConnect Remote 812 Manager “Home page,” selectMonitor > Networks > Network Status. You should see oneactive network for each of the LAN protocols configured (IP,IPX, and/or Bridge).You should also see an active network for each of theprotocols configured over each remote site. For example, ifyou have a remote site profile for Internet access, youshould see a corresponding IP network in the table.If you are connected to a remote office, with IP routing,you should see corresponding networks for this, too.The following is an example where an IP network isconfigured over the LAN (indicated by eth:1), and theremote site “red” is configured for IP over the WAN(indicated by atm:1).If you don’t see the expected networks, there is probably aremote site profile configuration error.2 Click Configuration > Remote Site (WAN).3 Check the following information on the WAN screen: Is the remote site enabled? Is the protocol (IP) enabled? Are the network addresses correct? Is the Network Service (PPP or RFC 1483) correct? Is the remote site profile ATM information (VPI / VCI)correct?NOTE: If necessary, contact your ISP or remote siteadministrator to confirm the information provided to you.When all problems are resolved, continue with IP testing.