Upgrading a Multi-Site System With No Branch Offices 1894 Start the Authentication and Directory service on the primary IP Telephonyserver and the secondary IP Telephony server by entering the followingcommands:cd /opt/3com/VCX/scripts/rc3.d./S20vcxdata start5 Start the Tomcat process on the primary IP Telephony server and thesecondary IP Telephony server by entering the following command:./S70tomcat startUpgrading aMulti-Site SystemWith No BranchOfficesSome VCX multi-site systems have regional offices but no branch offices.Each regional office contains a primary VCX server and a secondary VCXserver. These servers perform call processing and IP Messaging tasks. Oneof the regional offices also contains a Call Records server which gatherscall records from each of the regional offices.■ To upgrade the primary VCX server and the secondary VCX server,follow the instructions in Upgrading a Single-Site System With TwoServers earlier in this appendix.■ To upgrade the Call Records server, see the following section,Upgrading the Call Records Server.Upgrading the CallRecords ServerTo upgrade the Call Records server:1 Log in to the Call Records server as root.2 Stop all VCX processes on the Call Records server by entering thefollowing command:cd /etc/init.d./vcx stop3 Obtain a copy of the vcx-bss-7.1.xc.tar software upgrade file andplace it in the /opt/installtemp directory on the Call Records server.4 Enter these commands:cd /opt/installtemptar xvf vcx-bss-7.1.xc.tarcd upgrade-7.1.xc./install-upgradeThe system may prompt you to confirm that a new operating systemversion will be installed and indicates which disk partition will be usedafter the upgrade. If you see such a prompt, answer y.
