142 Parameters19.18 HAND/OFF disablesourceSelects the source for Hand/Off disable.1 = Hand and/or Off buttons are disabled on the panel and inDrive composer PC tool. Parameter 19.19 HAND/OFFdisable action specifies which buttons are disabled orenabled.If the HAND/OFF disable is activated while the drive is in theHand mode, the mode will be automatically switched to Offand the motor stops, and the user must start the motor again.Not activeNot active 0 = Hand and/or Off buttons are enabled and operational. 0Active 1 = Hand and/or Off buttons are disabled and not operational. 1DI1 Digital input DI1 (10.02 DI delayed status, bit 0). 2DI2 Digital input DI2 (10.02 DI delayed status, bit 1). 3DI3 Digital input DI3 (10.02 DI delayed status, bit 2). 4DI4 Digital input DI4 (10.02 DI delayed status, bit 3). 5DI5 Digital input DI5 (10.02 DI delayed status, bit 4). 6DI6 Digital input DI6 (10.02 DI delayed status, bit 5). 7Comms DCU profile control word bit 14 received through theembedded fieldbus interface.819.19 HAND/OFF disableactionSelects which buttons are disabled on the panel and in theDrive composer PC tool when parameter 19.18 HAND/OFFdisable source is disabled.HANDHAND Hand button disabled. 0OFF and HAND Both Off and Hand buttons disabled. 12020 Start/stop/direction Start/stop/direction and run/start enable signal sourceselection; positive/negative reference enable signal sourceselection.For information on control locations, see section Local controlvs. external control (page 37).20.01 Ext1 commands Selects the source of start, stop and direction commands forexternal control location 1 (EXT1).See also parameters 20.02…20.04.In1 StartNot selected No start or stop command sources selected. 0In1 Start The source of the start and stop commands is selected byparameter 20.03 Ext1 in1 source. The state transitions of thesource bits are interpreted as follows:1Reserved 2…3No. Name/Value Description Def/FbEq16State of source 1 (20.03) Command0 -> 1 (20.02 = Edge)1 (20.02 = Level) Start0 Stop
