Parameters 147Full text editor Enter your own text in the text editor. Not supported yet. 1320.48 Start interlock 1 text Alternative alarm texts for the start interlock 2. See parameter20.47 Start interlock 1 text.Startinterlock 2Start interlock 2 For other selections, see parameter 20.47 Start interlock 1text.020.49 Start interlock 1 text Alternative alarm texts for the start interlock 3. See parameter20.47 Start interlock 1 text.Startinterlock 3Start interlock 3 For other selections, see parameter 20.47 Start interlock 1text.020.50 Start interlock 4 text Alternative alarm texts for the start interlock 4. See parameter20.47 Start interlock 1 text.Startinterlock 4Start interlock 4 For other selections, see parameter 20.47 Start interlock 1text.020.51 Start interlockconditionSelects the condition for start interlock function.This parameter determines if the start command is neededbefore start interlock warnings are displayed.StartcommandignoredStart commandignoredStart interlock warnings are displayed if the interlocks aremissing.Start commandrequiredStart command must be present before the start interlockwarnings are displayed if the interlocks are missing.2121 Start/stop mode Start and stop modes; emergency stop mode and signalsource selection; DC magnetization settings.21.01 Start mode Selects the motor start function for the vector motor controlmode, ie. when 99.04 Motor control mode is set to Vector.Notes:• The start function for the scalar motor control mode isselected by parameter 21.19 Scalar start mode.• Starting into a rotating motor is not possible when DCmagnetizing is selected (Fast or Const time).• With permanent magnet motors, Automatic start modemust be used.• This parameter cannot be changed while the drive isrunning.See also section DC magnetization (page 76).AutomaticFast The drive pre-magnetizes the motor before start. The pre-magnetizing time is determined automatically, being typically200 ms to 2 s depending on motor size. This mode should beselected if a high break-away torque is required.0Const time The drive pre-magnetizes the motor before start. The pre-magnetizing time is defined by parameter 21.02Magnetization time. This mode should be selected if constantpre-magnetizing time is required (e.g. if the motor start mustbe synchronized with the release of a mechanical brake).This setting also guarantees the highest possible break-awaytorque when the pre-magnetizing time is set long enough.WARNING! The drive will start after the setmagnetizing time has passed even if motormagnetization is not completed. In applications wherea full break-away torque is essential, ensure that the constantmagnetizing time is long enough to allow generation of fullmagnetization and torque.1No. Name/Value Description Def/FbEq16
