Ordering informationContents of this chapterThis chapter lists the types and ordering codes of the unit components.You can find the kit-specific assembly drawings, step-by-step instructions and detailed kitinformation on the Internet. Go tohttps://sites-apps.abb.com/sites/lvacdrivesengineeringsupport/content. If needed, contactyour local ABB representative.Note:• This chapter only lists the installation accessories available from ABB. All other partsmust be sourced from a third party (such as Rittal) by the system integrator. For a listing,refer to the kit-specific installation instructions available athttps://sites-apps.abb.com/sites/lvacdrivesengineeringsupport/content. For access,contact your local ABB representative.• Parts that are labeled suitable for generic enclosures are not designed for any specificenclosure system. These parts are intended as a basis for further engineering, and mayrequire additional parts to be fully usable.Installation accessories designed for generic enclosures are in fact designed for aninside width of 50 mm less than the nominal width of the enclosure. For example, amechanical kit intended for 800 mm wide generic enclosure is designed for an insidewidth of 750 mm, and will not fit a 800 mm wide Rittal VX25 enclosure.Kit code keyThe kit codes shown in this chapter break down as follows.The format of the kit code is x-w-s-yyy(-VX), for example, L-6-8-401 where:• x = cooling method• A = air-cooled (some of these kits are also used with liquid-cooled drives)10Ordering information 91
