1.3 Product documentation1.3.1 Product documentation set GUID-3AA69EA6-F1D8-47C6-A8E6-562F29C67172 v15IEC07000220-4-en.vsdPlanning & purchaseEngineeringInstallingCommissioningOperationMaintenanceDecommissioningDeinstalling & disposalApplication manualOperation manualInstallation manualEngineering manualCommunicationprotocol manualCyber securitydeployment guidelineTechnical manualCommissioning manualIEC07000220 V4 EN-USFigure 1: The intended use of manuals throughout the product lifecycleThe engineering manual contains instructions on how to engineer the IEDs using the varioustools available within the PCM600 software. The manual provides instructions on how to setup a PCM600 project and insert IEDs to the project structure. The manual also recommends asequence for the engineering of protection and control functions, LHMI functions as well ascommunication engineering for IEC 60870-5-103, IEC 61850, DNP3, LON and SPA.The installation manual contains instructions on how to install the IED. The manual providesprocedures for mechanical and electrical installation. The chapters are organized in thechronological order in which the IED should be installed.The commissioning manual contains instructions on how to commission the IED. The manualcan also be used by system engineers and maintenance personnel for assistance during thetesting phase. The manual provides procedures for the checking of external circuitry andenergizing the IED, parameter setting and configuration as well as verifying settings bysecondary injection. The manual describes the process of testing an IED in a station which isnot in service. The chapters are organized in the chronological order in which the IED should becommissioned. The relevant procedures may be followed also during the service andmaintenance activities.The operation manual contains instructions on how to operate the IED once it has beencommissioned. The manual provides instructions for the monitoring, controlling and setting ofthe IED. The manual also describes how to identify disturbances and how to view calculatedand measured power grid data to determine the cause of a fault.Section 1 1MRK 504 158-UEN AIntroduction12Application manual
