12.2.1 IdentificationSEMOD167882-2 v3Function description IEC 61850identificationIEC 60617identificationANSI/IEEE C37.2device numberTrip matrix logic TMAGAPC - -12.2.2 Application M15321-3 v11The trip matrix logic TMAGAPC function is used to route trip signals and other logical outputsignals to different output contacts on the IED.The trip matrix logic function has 3 output signals and these outputs can be connected tophysical tripping outputs according to the specific application needs for settable pulse orsteady output.12.2.3 Setting guidelines M15291-3 v5Operation: Operation of functionOn/Off.PulseTime: Defines the pulse time when inPulsed mode. When used for direct tripping ofcircuit breaker(s) the pulse time delay shall be set to approximately 0.150 seconds in order toobtain satisfactory minimum duration of the trip pulse to the circuit breaker trip coils.OnDelay: Used to prevent output signals to be given for spurious inputs. Normally set to 0 or alow value.OffDelay: Defines a delay of the reset of the outputs after the activation conditions no longerare fulfilled. It is only used inSteady mode. When used for direct tripping of circuit breaker(s)the off delay time shall be set to at least 0.150 seconds in order to obtain a satisfactoryminimum duration of the trip pulse to the circuit breaker trip coils.ModeOutputx: Defines if output signal OUTPUTx (where x=1-3) isSteady orPulsed.12.3 Logic for group alarm ALMCALH GUID-64EA392C-950F-486C-8D96-6E7736B592BF v112.3.1 Identification GUID-64EA392C-950F-486C-8D96-6E7736B592BF v1Function description IEC 61850identificationIEC 60617identificationANSI/IEEE C37.2device numberLogic for group alarm ALMCALH - -12.3.2 Application GUID-70B268A9-B248-422D-9896-89FECFF80B75 v1Group alarm logic function ALMCALH is used to route alarm signals to different LEDs and/oroutput contacts on the IED.ALMCALH output signal and the physical outputs allows the user to adapt the alarm signal tophysical tripping outputs according to the specific application needs.1MRK 504 158-UEN A Section 12Logic185Application manual