Table 321:ORQT Input signalsName Type Default DescriptionINPUT1 BOOLEAN 0 Input signal 1INPUT2 BOOLEAN 0 Input signal 2INPUT3 BOOLEAN 0 Input signal 3INPUT4 BOOLEAN 0 Input signal 4INPUT5 BOOLEAN 0 Input signal 5INPUT6 BOOLEAN 0 Input signal 6Table 322:ORQT Output signalsName Type DescriptionOUT BOOLEAN Output signalNOUT BOOLEAN Inverted output signal15.7.6.3 Technical dataTable 323:Number of ORQT instancesLogic block Quantity with cycle time3 ms 8 ms 100 msORQT - 20 10015.7.7 Pulse timer function block PULSETIMERQTThe pulse timer function block (PULSETIMERQT) can be used, for example, for pulseextensions or for limiting the operation time of the outputs. PULSETIMERQT has asettable output pulse length.When the input goes to 1, the output will be 1 for the time set by the time delay parametert. Then it returns to 0.When the output changes value, the time stamp of the output signal is updated.The supported “quality” state bits are propagated from the input to the output at eachexecution cycle. A change of these bits will not lead to an updated time stamp on theoutput.PULSETIMERQT can propagate the quality, value and the time stamps of the signals viaIEC61850.1MRK 511 365-UUS A Section 15LogicPhasor measurement unit RES670 2.1 ANSI 449Technical manual
