ADJ Vizi Beam Hybrid 2R User Instructions

Also see for Vizi Beam Hybrid 2R: User manual

Contents

ADJ Products, LLC - www.adj.com - Vizi Beam Hybrid 2R Instruction Manual Page 213. Press UP or DOWN buttons, until “Lamp Off Time” is displayed,and press ENTER.4. “XXXX” will now be displayed. “XXXX” represents the runningtime of the lamp the last time that the lamp was On.5. Press ENTER or press MODE/ESC to exit.Last Run Password - This will display the timer password.1. Press the MODE/ESC button to access the main menu. Pressthe UP or DOWN buttons so that “Information” is highlighted, thenpress ENTER.2. Press the UP or DOWN buttons until “Time Information” is dis-played, press ENTER.3. Press UP or DOWN buttons, until “Last Run Password” is dis-played, and press ENTER.4. The “Last Run Password” is 038.5. Press ENTER or press MODE/ESC to exit.Clean Last Run - This will allow you to clear the last run time of theunit. You need to put in the Last Run Password before doing this.Please see the section before this.1. Press the MODE/ESC button to access the main menu. Pressthe UP or DOWN buttons so that “Information” is highlighted, thenpress ENTER.2. Press the UP or DOWN buttons until “Time Information” is dis-played, press ENTER.3. Press UP or DOWN buttons, until “Clean Last Run” is displayed,and press ENTER.4. Either “Off” or “On” will be displayed, use the UP and DOWN but-tons to toggle between.5. Press ENTER to confirm your selection or press MODE/ESC toexit.Lamp Time Password - This will display the lamp timer password.Vizi Beam Hybrid 2R System MenuADJ Products, LLC - www.adj.com - Vizi Beam Hybrid 2R Instruction Manual Page 38Vizi Beam Hybrid 2R Error CodesWhen power is applied, the unit will automatically enter a“reset/test” mode. This mode brings all the internal motors to ahome position. If there is an internal problem with one or moreof the motors an error code will flash in the display in the formof “XXer”, “XX” will represent a function number. For example,when the display shows “03Er,” it means there is some type oferror with the channel 3 motor. If there are multiple errors duringthe start-up process they will all flash in the display. For exam-ple: if the fixtures has errors on channel 1 and channel 3 all atthe same time, you will see the error message flash “01Er”, and“03Er repeated 5 times.If an error does occur during the initial start-up procedure thefixture will self-generate a second reset signal and try to realignall the motors and correct the errors, if the errors persist after asecond attempt a third attempt will be made.If after a third attempt all the errors have not been corrected thefixture will make the following determinations:1) 3 or more errors - The fixture cannot function properly withthree or more errors therefore the fixture will place itself in astand-by mode until subsequent repairs can be made.2) Less than 3 errors - If the fixture has less than 3 errors, there-fore most other functions will work properly. The fixture willattempt to operate normally until the errors can be corrected bya technician. The errors in question will remain flashing in thedisplay as a reminder of internal errors.01Er – PAN movement error:This message will appear after a fixture reset, if the pan-yoke’smagnetic-indexing circuit malfunctions (sensor failed or magnetis missing) or there is a stepper motor failure (defective motoror a defective motor IC drive on the main PCB).03Er – TILT movement error:This message will appear after a fixture reset, if the tilt mag-netic-indexing circuit malfunctions (sensor failed or magnet is