Installation138 Aastra 415/430 as of R3.2syd-0344/1.6 – R3.2 – 09.20144. 7. 5 Equipment on the ODAB options cardThe ODAB options card contains the following equipment:• 1 analogue terminal interface for connecting a door intercom• Control outputs and control inputs for connecting a door intercom and/or otherpurposes.With the aid of jumpers the options card is configured for connecting a door inter-com or provides control inputs and control outputs:• In the configuration as a door intercom the option card must be fitted to slot IC2(Aastra 415) or IC4 (Aastra 430). The interfaces are then available at RJ45 sockets2.1...2.3 (Aastra 415) and 4.1...4.3 (Aastra 430).• If the option card is used for other purposes, it must be fitted to slot IC1 (Aastra415) and IC1...3 (Aastra 430). The RJ45 socket x.1 then provides two control out-puts and the RJ45 socket x.2 two control inputs.• The possible RJ45 sockets are highlighted in colour in the figure below.Fig. 62 Interfaces of the ODAB options card4. 7. 5. 1 Connection of a door intercom (TFE)If the options card is fitted to slot IC2 (Aastra 415) or slot IC4 (Aastra 430), an ana-logue terminal interface is available for connecting a door intercom.Note:This analogue terminal interface cannot be used for other purposes asthe software does not support it.Jumper ConfigurationThe jumper configuration is shown in the following diagram. Three of the four IOports are used for connecting the door intercom. A control input or a control out-put is available for other purposes.
