Novell NetWare17Novell Remote Printer ModeRemote Printer AssignmentsIn remote printer mode the following assignments should be used, where SCxxxxxxis the device name.Device NetWarePort Printer Type Printer NameParallel 1 Remote Parallel, LPT1 SCxxxxxxParallel 2 Remote Parallel, LPT2 SCxxxxxx_P2Parallel 3 Remote Parallel, LPT3 SCxxxxxx_P3Serial Remote Serial, COM1 SCxxxxxx_SPRemote Printer Mode in NetWare 2.x, 3.xFollow the steps listed below to configure the Print Server to Novell Remote Printermode.1. Create QueuesFollow the steps below to create queues for the Print Server. If using existingqueues go to Step 2.(a) Run PCONSOLE program.(b) Select Print Queue Information (or skip to step 2.(a) if you do not need toadd new queues).(c) Press [INS] key to add a new queue.(d) Type a queue name, and press [ENTER].(e) Repeat Steps (c) and (d) until you have the desired number of queues.2. Assign printers(a) Run PCONSOLE, select Print Server Information(b) Select a NetWare Print Server.(c) Select Print Server Configuration.(d) Select Printer Configuration(e) Select printers that show Not Installed.(f) Enter the correct data in the Name and Type Fields. Refer to Remote PrinterAssignments on page 17.(g) Press [ESC], then select Yes.(h) Repeat steps (b) to (g) until all printers are assigned.(i) Press [ESC].3. Associate printers with print queues(a) Select Queues Serviced by Printer.(b) Select a printer you want to assign a print queue to.(c) Press [INS].(d) Select the queue that you want the printer to service, and press [ENTER].(e) Repeat Steps (a) to (d) until all printer and queue associations are configured.(f) Exit PCONSOLE
