50Chapter 7WindowsPeer-to-PeerThis chapter describes operation in a Windows Peer-to-PeerNetworking environmentSoftware RequirementsOperating SystemsWindows 95, Windows NT 4.0, Windows NT 3.51, or Windows for WorkgroupsLAN ProtocolsFor Windows 95 or NT, the following protocols are supported:• TCP/IP• NetBEUI• Windows SMB (Server Message Block)In Windows for Workgroups, the following protocols are supported:• NetBEUI• Windows SMB (Server Message Block)The procedures for each situation are described in the following sections.TCP/IPThe following steps must be carried out.• Software Installation• Device configuration• Software configurationSoftware InstallationSoftware installation must be carried out on every Windows 95 or Windows NTworkstation intended to use the Print Server’s printers.1. Run the SETUP program in the Driver\ptp_95nt folder on the CD-ROM.2. At the Select Components window, select the TCP/IP protocol.3. Once TCP/IP is selected, the Select Components screen will present 2 options:• Install Device Driver• Install SETBOX ProgramThe Device Driver needs to be installed on all workstations. The SETBOXprogram is only used to assign IP Addresses to the Print Server. If you are usingthe BiAdmin management program, you do NOT need SETBOX at all.Otherwise, SETBOX should be installed only on the system administrator’s PC.4. Complete the installation as normal. Reboot your system when setup is complete.5. The Setup program will do the following:7
