25Chapter 5TCP/IPThis Chapter explains how to configure and use the PrintServer in the TCP/IP environment.Software RequirementsThe Print Server can work with most UNIX systems and Windows NT 3.5 or later.Software required is:• TCP, IP, telnet, ftp (option - BOOTP, rarp)• Either LPD (NT, Unix) or C Compiler (for PSfilter under Unix).Device ConfigurationNote: The device should be configured FIRST.Configuration of your Print Server can be done by any of the following methods.♦ BiAdmin Management ProgramThis program requires Windows 95 or Windows NT. See Chapter 8 -Management Tools for details.♦ WebAdmin Management ProgramThis runs on an NT Server and is accessed by a WEB browser. See Chapter 8 -Management Tools for details.♦ FTP (File Transfer Protocol)With FTP, you copy the configuration file from the device, edit it, and send itback. Further information on using FTP is on pages 39 to 41.IP Address ConfigurationIn the TCP/IP environment, IP addresses are essential. The Print Server requires thefollowing IP Addresses to be entered. (The entry in brackets shows the line numberand token in the device’s configuration file.)IP Address(4000 IP_ADDR)Device IP Address. See the following section.Gateway Address(4001 GATEWAY)If your network segment has a router, enter the routeraddress here.If there is no router, leave the address as 0.0.0.0.Subnet Mask(4002 MASK)If the Gateway Address above is 0.0.0.0 the Subnet Maskshould also be left at 0.0.0.0.If you have a router, enter the Subnet mask for thesegment to which the Print Server is attached.5
