3-108container Commandscontainer show failoverTo display a list of failover disks assigned to an array, use thecontainer show failover command. You assign failoverdisks to an array with the container set failover command.Syntaxcontainer show failover [{container}]Parameters{container}Specifies the ID number (0 to 63) of the array whose assignedfailover disk(s) you want to display. If you do not specify thisparameter, the command displays all arrays and theirassigned failover disk(s).ExamplesThe following example shows the failover disks assigned to array 0:AAC0>container show failover 0Executing: container show failover 0container Scsi C:ID:L--------- ----------------------------------0 0:03:0 0:04:0The example shows that array 0 was assigned disks 0:03:0 and0:04:0 as failover disks.Related Commandscontainer commands: container remove failover (page 3-80) container set failover (page 3-95)
