9-2enclosure Commandsenclosure activate slotTo activate a device in a specified slot of the specified SAF-TEenclosure management device, use the enclosure activateslot command. Specifically, this command makes the device thatresides in the slot available on the SCSI channel.Syntaxenclosure activate slot {enclosure} {slot}Parameters{enclosure}Specifies the ID associated with the enclosure managementdevice on which you want to activate a device. For thisversion, the controller supports a maximum of eightenclosure management devices on each bus.{slot}Specifies the unit number associated with the slot. This is theslot that contains the device you want to activate. This unitnumber can range from 0 to 15 inclusive. Typically, the slotunit number is limited by the physical number of device slotsin the enclosure management device.ExamplesBefore activating a device, you might want to use the enclosureshow slot command to determine the current device state.As the following example shows, the current device state setting isNOTACTIVATE:AAC0>enclosure show slot 0Executing: enclosure show slot 0Enclosure Slot scsiId Insert Status--------- ---- ------ ------- -----------------------------0 0 0:00:0 4 OK UNCONFIG NOTACTIVATE0 1 0:01:0 0 OK UNCONFIG ACTIVATE0 2 0:10:0 0 OK UNCONFIG ACTIVATE0 3 0:03:0 0 OK UNCONFIG ACTIVATE0 4 0:04:0 0 OK UNCONFIG ACTIVATE1 0 1:00:0 0 OK CONFIG ACTIVATE1 1 1:01:0 0 OK UNCONFIG ACTIVATE1 2 1:10:0 0 OK UNCONFIG ACTIVATE1 3 1:03:0 0 OK UNCONFIG ACTIVATE1 4 1:04:0 0 OK UNCONFIG ACTIVATE
