4-7controller Commandscontroller firmware saveNote: This command is not supported in Linux.To save the contents of a controller’s flash in a pair of user flashimage (UFI) files, use the controller firmware savecommand. The names of the pair of UFI files are based on thecontroller type and cannot be changed.Syntaxcontroller firmware save[/C[{controller_ID}][{controller_ID}...] {/D{UFI_file_path}]Switches/C{controller_ID}Specifies the controller ID representing the set of controllerson which to perform the firmware save.If you do not specify this switch, this command saves theflash components on controller 0./D{UFI_file_path}Specifies the path where the pair of UFI files are located. Usethis switch to specify the drive and directory where you wantto create the pair of UFI files.If you do not specify this switch, this command creates thepair of UFI files in the current default drive and directory.ExamplesThe following example saves the contents of the opened controller’sflash components to a pair of UFI files. In the example, one file isspecified. A second file is also created with the same name, exceptthat the number of file name suffix is incremented by 1.AAC0> controller firmware save D:\aac\backup...Executing: controller firmware save “D:\aac\backup...”
