V6.230 2013101712511 SETTING FILESUploading and downloading of setting files can only be accomplished throughconnection from a PC directly connected to the TTC-1000. To save a setting fileon your PC use Upload Setting file. To transfer a previously stored setting filefrom your PC to the TTC-1000, use Download Setting file, or you can use the“Send CSV Settings To Unit” menu option to send a comma separated variablesettings file.11.1 Upload Setting FilesUpload settings transfers the binary settings to a designated file in a PCconnected through the RS232 communications port. The TTC-1000 uses theXMODEM protocol which is supported by HyperTerminal, HyperAccess, as wellas other terminal emulation programs. Checksum error checking is employed.11.1.1 Upload Settings Using HyperTerminalHyperTerminal as supplied in Windows XP does not work properly when scrollingback to view settings and is not recommended. The following instructions applyto both versions. In these instructions, HyperTerminal will stand for both versions,XP and Private Edition.The procedure to upload a setting file is as follows:1. Press Enter to display the TTC-1000 Main Menu.2. Press 6 and then press Enter:3. Click on Transfer on the HyperTerminal toolbar, a drop down menu willappear –a. Click on Receive File and a dialog box will openb. Select Xmodem from the Use Receiving Protocol optionc. Click on the Browse button and another dialog box will open wherethe directory can be selected to place the file.d. Click on Receive4. Another dialog box will open for entering the file name the file is to besaved as.a. Enter the file name and click on OK The three letter suffix will notautomatically be added. It is a good practice to add an ending suchas .BIN or .DAT to indicate it is not a text file. .5. Another dialog box will open that shows the file transfer progressa. HyperTerminal will try twice with CRC error detection to transfer thefile. The third attempt will be using Checksum, the method the TTC-1000 uses.b. The retry box will briefly show 3 and then the box will disappear.This means the file has been saved.
