V6.230 2013101747Therefore to display WINDING for Winding 1 type:Enter:47/1In a similar manner, the remaining winding names would be on program lines 48and 49.4.5.3 Setting Load NamesLoads can be selected from Table 4.4.Table 4.4: Load Names0 LOAD 7 BANK2A 14 PUMPC 21 LV1 LOAD1 LV LOAD 8 BANK2B 15 MOTOR 22 LV2 LOAD2 HV LOAD 9 BANK2C 16 LOAD13 TER LOAD 10 BANK1 17 LOAD24 BANK1A 11 BANK2 18 LOAD35 BANK1B 12 PUMPA 19 SER LOAD6 BANK1C 13 PUMPB 20 COM LOADProgramming from the front panel, enter the configuration program menu andpress the arrow button until the setting 050 is displayed:The same is true for settings 51-58 for the remaining eight loads, depending onhow many auxiliary CT input channels were purchasedPress the YES button. The first character will flash. Use the or arrow buttonsto scroll through the available names. Press YES after you have made yourselection.When programming from a PC the following are the valid codes for the windingnames available are shown in the table above.Therefore to display LV LOAD for Load 1 type:Enter:50/1In a similar manner, the remaining load names would be on program lines 51through 58.PRGM SETTING 050LOAD1 NAME=LOAD
