V6.230 2013101732First, you must press YES to begin entering the password. The zero will flash.Use the or buttons to scroll between the digits. The currently active digit willflash. Use the or arrow buttons to scroll through the digits 0 – 9. Press YESafter you have entered all four digits.If the password is correct, you will see the 1st setting of each PROGRAM menudisplayed on front panel (SP11PICKUP for SP, OUT1PUTMR for CFG, andIN1CTRL for TPM). Pressing the NO button at any time will bounce you back tothe password entry display.If the password is incorrect the display will read:There is no limit to the number of times you may try to enter a password.Fast scrolling through the front panel is available to navigate through the settingscreens more quickly. To use fast scroll mode, simply hold the UP or DOWNarrow buttons for more than 1.5 seconds. The unit will automatically scroll at afast rate until you release the UP or DOWN arrow button.4.2 Programming Settings Through a PCData communications from the TTC-1000 is implemented through the front panelmounted DB-9 connector at a fixed data rate of 9600 bits per second, 8 bits ofdata, no parity, and one stop bit. Operation has been verified with HyperTerminalPrivate Edition and HyperAccess. It is recommended that the terminal emulationbe set for either ANSI or TTY. The pin out of this port is designed to use a 9 pinfemale to 9 pin male null modem cable. You will need to configure your terminalemulation program before you get started.Units equipped with Tap Position Monitoring capability have three menucategories for programming their settings. Press the “Enter” key and observe thatthe Main Menu is displayed. The 2nd menu choice (2/xxxx) provides theprogramming capability for basic unit set point settings, the 4th menu choice(4/xxxx) provides the programming capability for the configuration settings, and11th menu choice (11) provides access to another sub menu that allows you toprogram the settings for extended functionality such as optically isolated digitalinputs and Tap Position Monitoring. Password is not required to enter thatsubmenu.On the “Enter Code:” line type “2/” followed by the four password digits to accessthe set point programming menu followed by “Enter”. If this is a new unit type“2/0000 “. If you are unsure if a password has been programmed, or you arehaving trouble type “2/0905 “ for the super user password. The list of settingswill scroll on the screen similar to the sample shown as follows:WRONG PASSWORDPASSWORD=0
