V6.230 2013101782Programming from the front panel, enter the Configuration menu and press the or arrow buttons until the setting 096 is displayed:Press the YES button. The first digit will flash. Use the or arrow buttons toscroll through the digits 0 – 9. Use the or buttons to scroll between thedigits. The currently active digit will flash. Press YES after you have entered allfour digits.For programming from a PC just type the new password on the “Enter:” line asfollows:Enter:96/2767It is important to remember to enter the password as a four digit number. Failureto enter a four digit number will result in an incorrect password.4.16 Setting Unit IDA six character unit identifier can be programmed. The unit ID is stored as asetting but also appears on the Status menu over the RS-232 interface.Programming from the front panel, enter the Configuration menu and press the or arrow buttons until the setting 095 is displayed:Press the YES button. The first digit will flash. Use the or arrow buttons toscroll through the digits 0 – 9. Use the or buttons to scroll between thedigits. The currently active digit will flash. Press YES after you have entered allfour digits.For programming from a PC just type the Unit ID on the “Enter:” line as follows:Enter:95/TX2767PRGM SETTING 096PASSWORD=0000PRGM SETTING 095UNIT ID=TX2767
