AXIS 570/670 User’s Manual Appendix J: Test Button 283Windows IBM Mainframe IBM AS/400UNIX NetWareOS/2MacintoshAppendix J Test ButtonThe test button is located on the front right hand side of the AXIS570/670 and is used for:• Printing a test page, checking the connection to the printer.• Printing a parameter list, showing the AXIS 570/670 current set-tings.• Resetting the AXIS 570/670 parameters to the factory defaultsettings.The Test Page Press the test button once to print a test page. If the test page prints,the parallel interface is functioning correctly. The printed Test Pagecontains basic information about the AXIS 570/670. It isrecommended that you print a test page every time you haveconnected the AXIS 570/670 to a printer.Note: o The test page is printed on LPT1 by default. If you want to printthe test page on LPT2 instead, you should set the InternalPrintout Destination parameter to LPT2.The Parameter List Press the test button twice to print a parameter list showing thecurrent AXIS 570/670 settings. This list provides comprehensivedetails of all the parameters and their current status. Refer toAppendix B - The Parameter List, on page 131.If you want to change any of the parameters, use one of the methodsthat are described inSection 11 Management & Configuration, on page 161.Note: o The parameter list is printed on LPT1 by default. If you want toprint the parameter list on LPT2 instead, you should set theInternal Printout Destination parameter to LPT2.
