Axis P1353-E User Manual

Also see for AXIS P1353-E: Installation guide User manual Installation guide

AXIS P1353–E Network CameraVideo and AudioExposure control - These settings is used to adapt to the amount of light used. Automatic is the default settings can be used in mostsituations. The shutter speed is automatically set to produce optimum image quality. Flicker-free 50 or 60 Hz is used to removeflicker which can be caused by fluorescent and other light sources. The Hold current option locks the current exposure settings.Enable Backlight compensation - Enable this option if a bright spot of light, for example a light bulb, causes other areas inthe image to appear too dark.Exposure zones - This settings determines which part of the image is used to calculate the exposure. For most situations, the Autosetting can be used. For particular requirement, select a predefined area.Shutter & GainThe shutter and gain settings affect the amount of motion blur and noise in the image. To adapt to different lighting, availablestorage space and bandwidth, it is often necessary to prioritize either low motion blur or low noise. The Axis product allowsusing different prioritization in normal light and in low light.Shutter speed is related to the amount of time the shutter is opened and is measured in seconds (s). A slow shutter speed allowsmore light to reach the sensor and can help produce a brighter image in low light situations. On the other hand, a slow shutterspeed can cause moving objects to appear blurry.Set Shutter to• Auto to set the shutter speed automatically. If required, use Max shutter to limit the shutter speed to prevent the framerate from being reduced. For example, to get 30 fps, set Max shutter to 1/30.• Fixed to use a fixed shutter speed.Gain, measured in decibel (dB), is the amount of amplification applied to the image. A high gain may provide a better image in lowlight situations but will increase the amount of image noise.Set Gain to• Auto to set the gain automatically. If required, use Max gain to limit the applied gain.• Fixed to use a fixed gain.When Shutter and Gain are both set to Auto, it is possible to set the Priority between low motion blur and low noise manually and touse a different Priority in Normal Light and in Low Light.ExampleConsider an area where people or vehicles move during the day, but where there should be no movements during night. To be able to,for example, recognize faces or license plates, move the normal light priority slider toward low motion blur. At nighttime, motiondetection is more important than identification. Motion blur is acceptable and since low light can cause a lot of noise, movethe low light priority slider toward low noise.ExampleIf storage space or bandwidth is limited, try using a lower gain. This will reduce image noise and produce smaller image files.Iris configurationIris configuration shows the current configured iris type. Do not change the iris configuration unless the lens has been changed,see Replacing the lens, on page 10.Iris adjustmentSelect Enable automatic iris adjustment to automatically compensate for changing light conditions. This option is not availableif a fixed iris is used.24