Axis P1353-E User Manual

Also see for AXIS P1353-E: Installation guide User manual Installation guide

AXIS P1353–E Network CameraSystem OptionsNoteThe initial password can only be set once. If the password is lost, the Axis product must be reset to factory default, seeReset to Factory Default Settings, on page 54.UPnPTMThe Axis product includes support for UPnPTM. UPnPTM is enabled by default and the product is automatically detected by operatingsystems and clients that support this protocol.UPnPTM can be disabled under System Options > Network > UPnPTM.RTP/H.264The RTP port range and multicast settings are configured under System Options > Network > RTP.The RTP port range defines the range of ports from which the video/audio ports are automatically selected. For multicast streams,only certain IP addresses and port numbers should be used.Select Always Multicast Video and/or Always Multicast Audio to start multicast streaming without opening an RTSP session.BonjourThe Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operatingsystems and clients that support this protocol.Bonjour can be disabled under System Options > Network > Bonjour.StorageSD CardNOTICENOTICENOTICETo prevent corruption of recordings, the SD card should always be unmounted before it is ejected.The Axis product supports SD cards with the following file systems:• ext4 — recommended due to its resilience against data loss if the card is ejected or if there is abrupt power loss. To accessdata stored on the card from the Windows operating system, a third-party ext4 driver or application is required.• vFAT — most SD cards are pre-formatted with vFAT when purchased.If required, the SD card can be manually formatted to the desired file system. To format the SD card:1. Insert the SD card in the SD card slot.2. Go to System Options > Storage and click SD Card.3. Click Format and select the desired file system.NoteDuring formatting any previous data stored on the disk will be lost.Mounting is done automatically when the card is inserted or when the product is started. A manual mount is only required if thecard has been unmounted and not ejected and re-inserted.To unmount the SD card:1. Go to System Options > Storage and click SD Card.2. Click Unmount.51