AW00123409000 FeaturesBasler ace USB 3.0 2191) Parameter is only available for color cameras.2) Parameter is not available for acA2000-165uc and acA2040-90uc cameras.3) Parameter is only available for use with the sequencer if the Gamma parameter value is setto 1 or if no light source preset is selected.4) Parameter is not available for use with the sequencer for the following cameras: acA1920-40,acA1920-155, acA2000-165, acA2040-55, acA2040-90, acA2040-120, acA2440-35, andacA2440-75.5) Parameter is only available for the following cameras: acA640-750, acA800-510,acA1300-200, acA1920-40, acA1920-150, acA1920-155, acA2000-165, acA2040-55,acA2040-90, acA2040-120, acA2440-35, and acA2440-75.7.7.2.2 Sequencer Set Related Parameters and Sequencer SetAdvanceSequencer Set Related ParametersTo each sequencer set the parameter values for the following sequencer set related parametersapply. The Sequencer Set Start parameter defines the first sequencer set that will be loaded into theactive set after the following two actions have occurred: the sequencer mode was set to On and the first frame start trigger was issued.For all Basler USB 3.0 ace cameras, the Sequencer Set Start parameter value must always beset to 0. This selects sequencer set 0 as the first sequencer set to be loaded and used for animage acquisition. The Sequencer Set Selector parameter selects a sequencer set by its index number. Selectinga sequencer set is necessary when configuring a sequencer set (see Section 7.7.3 onCounterDuration (for Counter 2) TimerDelay (for Timer 1)CounterEventSource TimerDuration (for Timer 1)CounterResetSource WidthSequencerSetStart CounterEventSourceSequencerSetSelector CounterResetSourceSequencerSetPath CounterDuration (for Counter 2)SequencerSetNextSequencerTriggerSourceSequencerTriggerActivation
