9A656-04/9A686-04 Configuration GuidePage B-1APPENDIX BDEFAULT SETTINGSThis appendix details the factory default settings that the 9A686-04 will use when firstinitialized.B.1 SMARTSWITCH 9500 SYSTEM SETTINGSThis section details the basic system settings that are set by default on the system upon firstinitialization.B.1.1 IP AddressesUpon first initialization, the chassis IP addresses (In-Band, Out-of-Band, and SMB-10) are allset to 0.0.0.0. Refer to Section 2.5.1 to set the IP Addresses.B.1.2 SNMP Community NamesThe factory default setting for community strings for all levels of access (superuser,read-write, and read-only) is “public”. Access to Local management screens may also beaccessed by pressing ENTER at the password screen. Refer to Section 2.6 to set newcommunity names.B.1.3 SNMP TrapsUpon first initialization, the SmartSwitch 9500 is configured to not send any traps to anyNMS. Refer to Section 2.7 to designate which stations will receive SNMP Traps from theSmartSwitch 9500.B.1.4 SignallingAll 9A686-04s installed in the SmartSwitch 9500 use ILMI 4.0 by default to determine whatSignalling stack to use on all interfaces. This allows for autoconfiguration of any type ofSignalling stack required by the device to which the interface is attached. Refer to Chapter 3for information on ILMI. Refer to Chapter 4 for instructions on hard setting the Signallingstacks for individual interfaces.
