9A656-04/9A686-04 Configuration Guide2-51SPVC Source Creation Screen2.24.3 Creating the Source End of a SPVCTo create the source end of a SPVC, perform the following steps:1. Use the arrow keys to highlight the SOURCE INTERFACE field.2. Enter a valid interface number. For example, Figure 2-25 displays a screen shot of a9A686-04 installed in slot 7 of the SmartSwitch 9500. Therefore, a valid source interfacevalue would be 70101 (port 1 of ANIM 1).3. Use the arrow keys to highlight the SOURCE VPI ENTRY field.4. Enter a valid VPI value.5. Use the arrow keys to highlight the SOURCE VCI ENTRY field.6. Enter a valid VCI value.7. Use the arrow keys to highlight the SOURCE ATM ADDR field.8. Enter a unique, 40 bit ATM address.9. Use the arrow keys to highlight the DESTINATION VPI field.10. Enter a valid VPI value.11. Use the arrow keys to highlight the DESTINATION VCI field.12. Enter a valid VCI value.13. Use the arrow keys to highlight the DESTINATION ATM ADDR field.NOTE In the following step, the available range for this field depends on the current ILMIsettings, and the amount of the VPIs currently being used by SVCs. Refer toSection 2.17 and Chapter 3 for more information ILMI.NOTE In the following step, the available range for this field depends on the current ILMIsettings, and the amount of the VCIs currently being used by SVCs. Refer toSection 2.17 and Chapter 3 for more information ILMI.!CAUTIONThe device that will support the destination end of this SPVC MUST have the sameVPI/VCI values assigned as those entered in steps 9 and 12. If the destinationdevice does not have the same VPI/VCI values assigned, the SPVC will NOT becreated.If the device that will support the destination end of this SPVC is another 9A686-04,refer to Section 2.25 for instructions on creating the destination end of the SPVC.
