9A656-04/9A686-04 Configuration Guide2-21The General Configuration ScreenScreen Refresh Time (Modifiable)Contains the rate at which the screens are updated. This setting determines how frequently (inseconds) information is updated on the screen. To enter a new update time, refer toSection 2.13.1.Screen Lockout Time (Modifiable)Contains the maximum number of minutes that the Local Management application displays amodule’s screen while awaiting input or action from a user. For example, if the number 5 isentered in this field, the user has up to five minutes to respond to each of the specifiedmodule’s Local Management screens. In this example, after five minutes of “idleness” (noinput or action), the terminal “beeps” five times, the Local Management applicationterminates the session, and the display returns to the Local Management Password screen. Toenter a new lockout time, refer to Section 2.13.2.FLASH Memory (Read-only)Displays the amount of FLASH memory installed in the 9A686-04.Default Gateway (Modifiable)Displays the default gateway for the 9A686-04. This field is not defined until an appropriatevalue is entered. For details about why and how to set the Default Gateway, refer toSection 2.13.4Default Interface (Modifiable)Displays the default interface for the 9A686-04. This field is not defined until an appropriatevalue is entered. For details about why and how to set the Default Interface, refer toSection 2.13.5.Base MAC Address (Read-only)Displays the base physical address of the module.TFTP Gateway IP Addr (Modifiable)Displays and allows the user to set the TFTP Gateway IP address for the 9A686-04. To set theTFTP Gateway IP address, refer to Section 2.13.3.2.13.1 Entering a New Screen Refresh TimeThe screen refresh time is set from 3 to 99 seconds with a default of 3 seconds. To set a newscreen refresh time, perform the following steps:1. Use the arrow keys to highlight the Screen Refresh Time field.2. Enter a number from 3 to 99.3. Press ENTER to set the refresh time to the time entered in the input field.