Chapter 2: System Configuration2-29A656-04/9A686-04 Configuration Guide• Viewing current SmartSwitch 9500 power supply information via the Chassis PowerScreen.• Configuring ILMI to set minimum and maximum VCI and VPI levels of SVCs and SVPCsand to reserve VCI/VPI pairs for PVCs.• Changing the NSAP prefix of the SmartSwitch 9500 from the default value.• Changing the PNNI addressing mode, and PNNI level from the default values.• Configuring the EPD/PPD percentage for individual modules in the chassis.• Configuring SPVCs and SPVPs.• Changing the management LAN Emulation Client from the default values.• Using the Network Tools suite of commands for additional status and configurationoperations.• Viewing the current status of the Environmental Module of the SmartSwitch 9500 chassis,configuring the settings of the COM ports of the EM, and instructions on downloading anew firmware image to Flash memory of the EM.• Creating a PVC via the AToM MIB.2.1 SELECTING LOCAL MANAGEMENT MENU SCREEN ITEMSSelect items on a menu screen by performing the following steps:1. Use the arrow keys to highlight a menu item.2. Press ENTER. The selected Local Management screen displays.2.2 EXITING LOCAL MANAGEMENT SCREENSThere are two ways to exit Local Management (LM).Using the EXIT CommandTo exit an LM screen using the EXIT command, proceed as follows:1. Use the arrow keys to highlight the EXIT command at the bottom of the LocalManagement screen.2. Press ENTER. The Password screen displays and the session ends.Using the RETURN Command1. Use the arrow keys to highlight the RETURN command at the bottom of the LocalManagement screen.2. Press ENTER. The previous screen in the Local Management hierarchy displays.
