Chapter 1: Changes to Local Management Screens1-18Local Management SupplementLINK STATUS (Read-only)Indicates whether there is a physical connection from this port to anotherEthernet device. One of the following values displays:• Link – A link signal is present; there is a valid physical connectionfrom this port to another device.• No Link – No link signal is present; there is no valid physicalconnection from this port to another device.PORT STATUS (Read-only)Indicates whether the port was turned on or off administratively (by theuser). One of the following values is displayed:• ENABLED – The port is turned on administratively.• DISABLED – The port is turned off administratively.SET ALL PORTS (Toggle)All front panel ports can be set at once to either STANDARD or FULLDUPLEX from this field. To set ports, refer to Section 1.7.1.[1-12], [13-24], [25-36], or [37-48] (Navigation Key)When the Full Duplex Configuration screen displays, the currentoperation mode and status information are displayed for the first 12 ports.This field allows the user to step to another screen for the same type ofinformation for ports 13 through 24, 25 through 36, and 37 through 48, ifavailable. The number of ports available is dependent on the SmartSwitchmodel. To navigate to the next screen, highlight the [xx-xx] field and pressENTER. The user can change the Operation Mode fields while in any ofthe selected screens.1.7.1 Setting the Operational ModeThe Operational Mode may be set to Standard Ethernet or Full Duplexeither one port at a time or all at once. The following steps describesetting the port Operational Mode for individual ports followed by stepsto set the Operational Mode for all ports.NOTEEnabling or disabling ports from the Switch Configurationscreen is described in Section 1.16.3.
