Cabletron Systems SmartSwitch 2H22 Supplemental Manual

Also see for 2E43-51R: User guide

Contents

Cabletron Systems SmartSwitch 2H22 Supplemental Manual Manual pdf 94 page image

Chapter 3: LM Security Screens for 2H23-50R/2H33-37R Devices3-10Local Management Supplement5. Use the arrow keys to highlight the SendTrap field.6. To change the SendTrap setting to NoTrap, press the SPACE bar totoggle the setting.7. To change the security on more than one connector, repeat steps 1through 6 for each connector. Then proceed to step 8 to save allsettings at once.8. Use the arrow keys to highlight the SAVE command.9. Press ENTER. The message “SAVED OK” displays and all ports ofthe connector are set to the selected operating mode.3.4 PORT LEVEL SECURITY CONFIGURATIONSCREENThe Port Level Security Configuration screen, Figure 3-4, is used to setthe security of each port of a selected connector.To access the Port Level Security Configuration screen, use the arrowkeys to highlight the PORT LEVEL SECURITY CONFIGURATIONmenu item on the Repeater Configuration Menu screen and press ENTER.The Port Level Security Configuration screen displays.NOTEIf LockedOnAddr is chosen as the Security State, the addressof the repeater ports must be configured in the Port LevelSecurity Configuration screen. Refer to Section 3.4.