Using the TSX-1620 Hub View2-6Using the Hub ViewThe TSX-1620 Application DisplaysThe TSX-1620 Hub View has two different application display modes: Interfaceand Bridge. Each mode features different port display forms and offers differentmenus. The Interface application display is shown by default when the TSX-1620Hub View is launched. To switch between the Interface and Bridge applicationdisplays:1. Click on the module index or module type, at the top of the TSX-1620 portdisplay column in the Hub View (see Figure 2-4, below). The Module menuwill appear.2. Drag down to Application Display, then right to Interface or Bridge,depending on your intended selection. The Hub View will change to reflectyour selection.Figure 2-4. Changing the TSX-1620 Application DisplayWhen you change the application display mode, the port display form willchange to the default form for the chosen mode. For the Interface applicationdisplay, the default port display form is Oper Status. For the Bridge applicationdisplay, the default port display form is Admin. You can change the port displayform from either application display mode using the Port Display Form selectionfrom the Interface or Bridge menus. For details on the port display form selectionsavailable for each application display, see Port Display Form, later in this chapter.Each application display mode offers some different menus and menu selections,as illustrated in Figure 2-5 and Figure 2-6, below.
