Managing the Device2-19Using the TSX-1620 Hub View3. To define permissions for the selected entry, click on the Read Only or ReadWrite option, as desired. The selected permission will be reflected in the listentry.4. To establish an IP address to which SNMP traps will be sent, highlight thecontents of the Trap IP field, type the desired IP address, and press Enter orReturn on your keyboard. The selected list entry will change to reflect the newtrap IP address. The default value for this field is 0.0.0.0; if this field is left atthe default value, no traps will be sent.The Refresh button initiates a new request for Community Name information.When this button is clicked, the TSX-1620 will be queried for its community nameconfiguration, and any changes that have occurred since the window was opened(or since the Refresh button was last clicked) will be reflected in the CommunityName window.Configuring Your TSX-1620’s Serial PortThe Console Config utility allows you to configure your TSX-1620’s serial (localmanagement) port. Using the Console Config window you can view the port’shardware type, select its speed, define the number of bits per character and stopbits, configure the parity and flow control, and enable or disable ANSI graphicsfor the port. To launch the Console Config window from the TSX-1620 Hub View:1. Click on the module index or module type to display the Module menu (seeFigure 2-3 on page 2-5).2. Drag down to Module Utilities, then right to Console Config, and release.
