Cabletron Systems WPIM T1 User Manual

Cabletron Systems WPIM T1 User Manual Manual pdf 20 page image

Chapter 2: Setup and Installation2-2WPIM-T1/DDS User’s Guide2.1.2 Pre-InstallationTo prepare the host platform for the WPIM-T1/DDS, proceed as follows:1. Turn off and disconnect the host platform from the power source.2. Mark all network cables attached to the host platform for ease ofre-installation.3. Disconnect all network cables attached to the host platform.4. Refer to detailed instructions contained in the host platform’s userguide to remove the chassis cover. This procedure must be completedbefore installing the WPIM-T1/DDS.2.1.3 Installing the WPIM-T1/DDSTo install the WPIM-T1/DDS into the device, refer to Figure 2-1 andcomplete the following steps:1. Remove the blank faceplate from the appropriate WAN slot byremoving the three WPIM screws that secure it to the standoffs.2. Orient the WPIM-T1/DDS as shown in Figure 2-1.3. Carefully insert the WPIM-T1/DDS connector into the WPIMconnector pins on the device.4. Press down firmly on the WPIM-T1/DDS until the pins slide all theway into the connector. Ensure that the WPIM-T1/DDS seats flush onthe standoffs.5. Secure the WPIM-T1/DDS to the three standoffs with the WPIMscrews.!CAUTIONWhen removing an existing WPIM, make sure to pull themodule straight up to avoid damaging the connector.