![Cabletron Systems WPIM T1 User Manual Manual pdf 27 page image](https://manuals-archive2.s3.amazonaws.com/2831353/e25cc68221e0ccca3da2b5145782128b27f.jpg)
The WAN Physical Configuration ScreenWPIM-T1/DDS User’s Guide3-33.1.1 WAN Physical Configuration Screen FieldsThe following sections describe WAN Physical Configuration screenfields and provide instructions for setting them. The WAN PhysicalConfiguration screen lets you configure the WPIM or “PhysicalInterface.”To select the WPIM you wish to configure, proceed as follows:1. Use the arrow keys to highlight the WPIM X command field at thebottom of the screen.2. Use the SPACE bar to select the appropriate WPIM, then pressENTER. The WAN Configuration screen automatically displaysunique configuration fields for each WPIM as shown in Figure 3-1.The WAN Physical Configuration screen displays the followinginformation for each WPIM:WPIM1-2 (Read-Only)Displays configuration information for up to two different WPIMs.Type (Read-Only)Displays the type of WPIM installed. For the WPIM-T1/DDS, the Typefield displays the service selected. When T1 service is selected, T1 isdisplayed. When DDS service is selected, DDS is displayed.WPIM # (Read-Only)Displays the number of the slot in which the WPIM resides.Mgr Type (Selectable)Used to select the type of protocol manager. For the T1 mode of theWPIM-T1/DDS, the available options are PPP, FR PtoMP, FR PtoP,HDLC and NONE. The field defaults to NONE.Max VCs (Modifiable)Displays the maximum number of virtual circuits (interfaces) available tobe configured. The default number displayed depends on the ProtocolManager chosen.Next IF (Read-Only)Displays the next interface available to be used.NOTEThe Type field displays either T1 or DDS, depending on themode selected using Network Tools.