Cabletron Systems WPIM T1 User Manual

Cabletron Systems WPIM T1 User Manual Manual pdf 51 page image

WAN Interface Configuration ScreenWPIM-T1/DDS User’s Guide4-54.2 WAN INTERFACE CONFIGURATION SCREENThis section describes the features of the WAN Interface Configurationscreen. Access the screen by using the arrow keys to highlight the WANINT CONFIG command field at the bottom of the WAN PhysicalConfiguration screen, then press ENTER. The WAN InterfaceConfiguration screen shown in Figure 4-2 displays.Figure 4-2 WAN Interface Configuration Screen4.2.1 WAN Interface Configuration Screen FieldsThe following sections describe WAN Interface Configuration screenfields.Interface Number (Modifiable)Displays the active Interface Number. Use this field to configure theInterface Number assigned to the timeslots on the WAN PhysicalConfiguration screen.Max Xmit Unit (Modifiable)User configured field that displays the maximum packet size that can betransmitted on the selected interface. The default settings for this field(1526 for PPP and 4095 for Frame Relay) depend on the ProtocolManager selected.WAN INTERFACE CONFIGURATIONRETURNSAVEInterface Number: 000Max Xmit Unit: 0ProtMgrIface: [0]Active Protocol: FRFR LMI: [ANSI_94]DLCI Address: 0DLCI DCP En:DLCI DCP Stat:Comp Ratio:Circuit State: [Invalid]2750_02 Local Management Flash Image Version: xx.xx.xx001002003004005006007008009010011012013014015CKT# IF# LID STATE018019020021022023024025026027028029030031032CKT# IF# LID STATE016017001 Enet UP002 Enet DOWNPORTS:[1-32]