Cabletron Systems WPIM T1 User Manual

Cabletron Systems WPIM T1 User Manual Manual pdf 41 page image

Frame Relay ConfigurationWPIM-T1/DDS User’s Guide3-173.4.2 T1 Interface ConfigurationThe WAN Interface Configuration screen is accessed through the WANPhysical Configuration screen. Access the WAN Interface Configurationscreen by using the arrow keys to highlight the WAN INT CONFIGcommand and press ENTER. Refer back to Figure 3-4 and proceed withthe following steps to configure the WAN Interface.1. Set the WAN connection Interface Number by typing the samenumber into the Interface Number field that was input into thetimeslots in the WAN Physical Configuration screen, then pressENTER (refer to the Note on page 3-16).2. Unless the user sets the Max Xmit Unit, the WPIM-T1/DDSautomatically sets the Max Xmit Unit to 1526 (default) after theactive protocol (PPP) is selected.3. Make any changes to the available settings as desired.4. Use the arrow keys to highlight the SAVE command, then pressENTER. The message “Save Done!” appears and Local Managementsaves the changes to memory.The WAN configuration is complete. It takes up to 60 seconds for theWAN Interface to come out of standby and for communications to begin.3.5 FRAME RELAY CONFIGURATIONThis section provides step-by-step instructions for configuring theWPIM-T1/DDS to use a T1 circuit in a Frame Relay environment. Thisexample assumes the setup shown in Figure 3-8 using two CSX400s, eachwith a WPIM-T1/DDS installed. Configurations may vary depending onthe host platform.Figure 3-8 Frame Relay ConfigurationSITE #1 Telco Cloud24 Timeslots24 TimeslotsSITE #21482_05