Canon Arizona 1300 Series User Manual

3. Bend the height adjuster (small triangle in the top corner of the edge protector) slightly and thenstraighten it again. This results in a slight bend (no more than a media thickness), that allows themedia edge to move more freely under the protector.[48] Media Edge Protector Height AdjusterIMPORTANTIf the height adjuster area is higher than 1 mm from the platen, there is a possibility thatthe carriage may hit the edge of the protector and thus damage printhead nozzles.4. Peel the backing layer from the double-sided tape on the back of the protector.5. Place the bent edge of the protector into the media cut guide, but do not press down on the tapeyet.6. Slide the protector towards the media edge until the inside edge of the height adjuster ispositioned over the media edge (see figure below).NOTEDo not let the plastic edge near the arc butt up against the media edge or the device maynot let the media pass smoothly.The vacuum in the platen will hold the main part of the protector in place while the imageis printed.Media Edge Protectors118 Chapter 7 - Roll Media Option